"How perform I set my vintage pocket watch?" is just one of the most typical questions we"re asked. Plenty of vintage pocketwatches room lever-set models, which are not collection by pulling the end the winding crown.

You are watching: How to change time on a pocket watch

Lever-setting was a feature of greater quality (often railroad-grade) pocket watches that was to plan to protect against them from being accidentally reset come an not correct time. In fact, lever-setting to be a requirement of the general Railroad Timekeeping Standards. Lever-setting usually calls for that the bezel be removed (or opened) and also that a tiny setting-lever be relocated in order to ar the clock in "setting" mode.

Here"s the correct way to set the time on your lever-set watch. This example uses a Hamilton 992B Railway Special, however the instructions are very similar for any lever-set bag watch.


*

Hold the clock in dial-up position. Execute this while sitting comfortably v the watch held low end a table or a padded surface ar so the it"s no going to autumn a long means if friend accidentally drop it. Don"t do this when standing ~ above a ladder in your driveway!


*

Gently screw turn off the former bezel (the ring the holds the crystal). Lever-set watches practically always have actually screw-off bezels. Don"t forget: righty-tighty, lefty-loosey!

On hunter-cased the town hall (those with a lid over the dial), friend don"t have to screw turn off the bezel. Once you open up the prior cover over there is commonly a little notch in the bezel that the set-lever rod through. Just look closely and you"ll check out it.

Occasionally, a lever-set watch may be discovered in a various style of instance (hinged-bezel, for example). If therefore you"ll should open the bezel come gain accessibility to the setting lever.


*

Find the setting lever (indicated here by the tip I"m holding). You will see simply the pointer of the lever projecting from beneath the dial. The bar on her watch may be in a different location than this one. Over there is usually a notch cut in the pickled in salt of the instance to accommodate the lever. Girlfriend don"t need any kind of tools to perform this, I"m just using this needle as a pointer.

Usually the set-lever is approximately the 1:00 position or about the 5:00 position on the watch.


*

Hook the guideline of the setting lever v your thumbnail and slide it straight out indigenous the watch.

Any time you have the bezel turn off the watch, it is in extra mindful not come hook the reminder of the hands with your finger or change the alignment of the hands. They must remain straight, level and parallel through the dial.


*

With the bar in the "set" position, rotate the crown (the winding button) and you will be maybe to collection the time. ~ you"ve collection the watch, press the lever back in to "wind" position and replace the bezel on the watch.

See more: How Tall Is Maxwell The Singer Maxwell Haitian? How Tall Is Maxwell

Be careful to obtain the bezel threaded-on appropriately as they room a actual pain if you acquire them cross-threaded! If it seems to it is in cross-threaded, don"t pressure it! Just earlier it up till it is to adjust properly and also it have to go on easily.